- #1
JayKo
- 128
- 0
Fabrication of Single Junction GaAs Solar Cell by MBE
Hi All,
My project is to produce 1 single piece of GaAs solar cell (about the size of 1cm square) by MBE technique. I have gone through some read up and simulation software software called atlas by silvaco. for time being, I am testing on other sample to do the thermal evaporation and photo lithography. how ever my question is.
how do i connect the bottom contact layer with the top electrode layer so as to achieve maximum current for my I V characteristic measurement.
I have some very rough sample shown in the picture below, and I try to search through the net but to no avail. I would be most grateful if you guys could give me some valuable inputs.
thanks
Jayko
http://img137.imageshack.us/img137/4448/solarcell.jpg
Uploaded with ImageShack.us
The 2 fine wires on top is the gold wires (cathode) the bottom is connected to copper foil (anode)
Hi All,
My project is to produce 1 single piece of GaAs solar cell (about the size of 1cm square) by MBE technique. I have gone through some read up and simulation software software called atlas by silvaco. for time being, I am testing on other sample to do the thermal evaporation and photo lithography. how ever my question is.
how do i connect the bottom contact layer with the top electrode layer so as to achieve maximum current for my I V characteristic measurement.
I have some very rough sample shown in the picture below, and I try to search through the net but to no avail. I would be most grateful if you guys could give me some valuable inputs.
thanks
Jayko
http://img137.imageshack.us/img137/4448/solarcell.jpg
Uploaded with ImageShack.us
The 2 fine wires on top is the gold wires (cathode) the bottom is connected to copper foil (anode)
Last edited by a moderator: