- #1
fahcue
- 1
- 0
Hello, I'm not sure if this is where I need to be, but here goes. I have a Currie 24 volt ESC for an electric scooter, I also have a generic one that is 36 volts, both work perfect, my question is the 24 volt is built much, much better than the 36 volt, what I would like to do is swap the parts from the 36 into the 24 volt thus making it a higher quality 36 volt esc. I hope this makes sense. I worked in t.v. repair so soldering etc is no problem. Now I don't know what parts handle the voltage rateings, I'm sure the mosfets, caps , etc will have to be swapped but I don't know the details, this is just an idea so if it's not possible no biggie. The 24 volt has much heavier wires, connectors, and the internal parts are better also, board, heat sinks, etc. Thanks.