- #1
emaN resU
- 6
- 0
Ok, first post so be nice guys!
I've designed and simulated a design for controlling a brushed DC series motor in OrCAD and it does what i was aiming for it to do. Which is to step down voltage to an average of 50% with duty cycle at 50% etc.
I thought I had it all figured out but recently I've got really confused about what I am doing. :P
Ok so I thought I had designed a Buck converter see figure below:
However from the link below it seems that i have designed a Boost Chopper, which is really confusing me. Can someone please just explain to me what the hell i have done?
http://www.microsemi.com/catalog/pa...0&P1_Voltage1=600&P2_PMType=PMIGBT&P3_CONF=47
emaN resU
I've designed and simulated a design for controlling a brushed DC series motor in OrCAD and it does what i was aiming for it to do. Which is to step down voltage to an average of 50% with duty cycle at 50% etc.
I thought I had it all figured out but recently I've got really confused about what I am doing. :P
Ok so I thought I had designed a Buck converter see figure below:
However from the link below it seems that i have designed a Boost Chopper, which is really confusing me. Can someone please just explain to me what the hell i have done?
http://www.microsemi.com/catalog/pa...0&P1_Voltage1=600&P2_PMType=PMIGBT&P3_CONF=47
emaN resU