- #1
Manojg
- 47
- 0
Hi everybody,
I have a experimental question. In cross-section calculation of production of particles (say D), one counts the number of produced D. To selection the D one has to apply some kinematic cuts. If cuts are tight, number of D will be less and if cuts are loose, number of D will be large. So, cuts is going to effect the calculated cross-section. How these effect is taken into account?
Thanks.
I have a experimental question. In cross-section calculation of production of particles (say D), one counts the number of produced D. To selection the D one has to apply some kinematic cuts. If cuts are tight, number of D will be less and if cuts are loose, number of D will be large. So, cuts is going to effect the calculated cross-section. How these effect is taken into account?
Thanks.