Register to reply

Why do I need a processing code when I pair Arduino with bluetooth

by marellasunny
Tags: arduino, bluetooth, code, pair, processing
Share this thread:
marellasunny
#1
May11-14, 06:46 AM
P: 226
I have a need to connect my [Arduino+Bluetooth dongle JY-MCU V1.02] to my laptop in-built bluetooth device.Most forums suggest using a processing code to go ahead and do this http://www.instructables.com/id/Succ...dule/?ALLSTEPS.
"Demonstration of a Processing client searching for and connecting to a service."
Name of processing library: Bluetoothdesktop library by extrapixel.

Now,I am a mechanical engineer with very little/no idea of how the processing code goes about in establishing the bluetooth device on my laptop as master. In simple words,it looks like the processing code controls the devices in-built in my laptop whereas the arduino code controls the signals to and from the arduino.Is that right?
Phys.Org News Partner Engineering news on Phys.org
Hoverbike drone project for air transport takes off
Student develops filter for clean water around the world
Developing the next evolution in underwater communication

Register to reply

Related Discussions
Arduino Serial port greyed out? Electrical Engineering 5
Bluetooth components selection? Any already made devices? Electrical Engineering 6
Math name for asymetric-pair relationship? General Math 1
A high-energy photon creates a pi+ pi- pair. ? Advanced Physics Homework 4
Use of the term pair vs ordered pair Set Theory, Logic, Probability, Statistics 4