AC Motor Capacitors: Wiring, Diagrams & Troubleshooting

AI Thread Summary
The discussion revolves around troubleshooting an AC motor that was purchased with unconnected capacitors. The user provided links to the capacitors and the motor's wiring diagram but faced difficulties in getting the motor to power on, even when bypassing the capacitors. After several attempts, the user eventually managed to get the motor working through trial and error. The conversation highlights common challenges in wiring AC motors and the importance of understanding the connection of capacitors. Ultimately, the user found a solution despite initial setbacks.
Shawnzyoo
Messages
104
Reaction score
0
I picked up a good and cheap AC motor that came with its own capacitors <not wired in though>
The capacitors are these
http://www.weisd.com/store2/NTEMRC370V7R5.html
and this is the diagram on the motor
http://foxhole.kicks-ass.net/diagram.jpg"
Now I tried putting this together but with no luck at all
the motor doesn't seem tohave power at all even if i just straight hook it up without the caps.
am I doing something completely wrong here?
 
Last edited by a moderator:
Engineering news on Phys.org
alas sorry for this wasted post
but I just got it working through trial and error
 

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Similar threads

AC motor rotary capacitor soft start
Replies
5
Views
2K
How to make an Electrical Diagram with added Steinmetz Circuit for a Delta 3 phase motor?
Replies
0
Views
2K
Why is my new 1ph AC motor overheating?
Replies
3
Views
2K
How can I wire a bipolar stepper motor to switches for my laser engraver?
Replies
11
Views
2K
Farm Motor Capacitor Replacement
Replies
17
Views
4K
Current Surge Capacitor Calculator
Replies
5
Views
4K
Help w/ Single Phase AC Motor wiring? (not HW)
Replies
4
Views
17K
Design choices for running an Electric train (and network)?
Replies
6
Views
2K
Super capacitor for running DC motor
Replies
2
Views
5K
Reason and remedy for AC motor overheating?
Replies
14
Views
49K

Hot Threads

Recent Insights

Back
Top