Recent content by happyuser123

I am looking for the most economocal option for the project. I would also greatly appreciate if you can please also list everything else I will need for this to work. Thanks again!

I found the diagram for the driver that I am trying to switch the signal from/currently on the board: http://www.allegromicro.com/en/Products/Part_Numbers/3977/3977.pdf

If it would be possible for you to draw a quick diagram, so that I can understand your suggestion better, that would be extra greatly appreciated! Thanks in advance for everyone that's so kind to help me with this project!

Hi, the stepper motor that's now connected is this: http://www.shinano.com/xampp/docs/SST41D.pdf Also, how would I power the motors? and add that second driver for the second new stepper motor??

Hi, I have a epson c88+ printer, I am trying to modify the Allegro A3977 Microstepping Driver, to move the incoming signal for the stepper motor and send it to 2 additional stepper motor drivers, so that I can run 2 stepper motors off that same signal. I have little experience in this...