Recent content by Melon

Yes, I set lumped RLC on 2D sheet in HFSS. And when its size changes, the result changes too. So I want to know how can I set a resistor/inductor/capacitor in HFSS without the influence of sheet size.

Hi Guys When I use lumped RLC in HFSS, I find that its size can influence the simulation result. How do I set the sheet size of lumped RLC? Make it square is better? Thanks.

Thanks. So I will set 1 for number of conductors when I use Litz wire type. Thanks for your help.

Hi guys, I wonder when I have defined the strand number of litz wire in copper material properities in Maxwell 3D, should I keep number of conductors in coil terminal added in a winding the same as number of of litz strand? For example, 2 for strands litz wire and then 2 for number of...

Hi Guys, In AEDT, when should we use Mechanical_Thermal or Icepak? Do you have any advice? Thanks!

Hi Guys, I am doing a air coil thermal simulation by Maxwell 3D&Icepak to verify its rated cueernt. First I use Maxwell 3D DC solution type to load DC current and get about 6cel temperature rise in Icepak. But then I want to try this in Maxwell 3D Eddy Current solution type, so I load stranded...

Hi Guys, I am doing a Maxwell 3D&Icepak thermal simulation for a air coil. I want to get its temperature when loading 1.6A current. So I use Eddy Current type in Maxwell 3D and Temperature and Flow type in Icepak. Then I load 1.6A solid current and adaptive frequency of 800 MHz for the coil...