Recent content by playludesc

  1. P

    Pulley-to-Shaft-to-Pulley Calculation?

    Nah, blue pulley will be a timing belt pulley, I'm just trying to figure out exactly what size to make it, which in the calculation/selection phase makes it the variable. I've got a ported M62 going on the H22a4 in my fifth generation Prelude.
  2. P

    Pulley-to-Shaft-to-Pulley Calculation?

    Thanks very much for taking the time to answer so thoroughly. I think sophie confirmed that I'm on track for my application. Even so, I'll wrap my English degree head around your post and get back to you in a bit!
  3. P

    Pulley-to-Shaft-to-Pulley Calculation?

    That's what I thought. Sorry if my phrasing was confusing. I'm just asking if my method of calculating the "out" speed for the blue pulley is correct in my second post. Your posts seem to agree with my method, so we're good!
  4. P

    Pulley-to-Shaft-to-Pulley Calculation?

    Right, would the belts' speed be directly proportional, like in my calculation above? Or should I be using a different formula?
  5. P

    Pulley-to-Shaft-to-Pulley Calculation?

    So I figured that this is probably a simple mechanical advantage equation, as the two pulleys simply work like levers on each other. Here's what I ended up with: Blue pulley diameter = 1.835" Black pulley diameter = 2.000" Black pulley RPM = 22,023.5 1.835/2.000 = 0.9175...
  6. P

    What If the Big Bang Was Caused by Another Universe?

    I'm well aware :) Any speculation as to what happened before our big bang is only that. I apologize for my loose usage of the term "theory".
  7. P

    What If the Big Bang Was Caused by Another Universe?

    My personal favorite theory on what happened before the big bang involves a truly infinite universe in which there are infinite big bangs that explode a certain points, and expand outward to eventually crash into each other. This allows for each big bang to accelerate as quickly as ours is...
  8. P

    Pulley-to-Shaft-to-Pulley Calculation?

    Hello all! I'm working with a particular pulley configuration and I realized after a few calculations that I don't have an accurate way to calculate one part of the set up. Here's a quick MSPaint sketch showing what I need to solve for. If I know the outer diameter of both pulleys, and the...
Back
Top