I think we need to clarify what you want to achieve and what is feasible.
Do you want to design an engine, or do you want to draw a picture of one?
3D CAD is essentially an elaborate drawing.
I'm looking to calculate the ratio of a planetary gear train. With the ultimate goal of producing a spreadsheet/calculator to show the state of the gearbox (i.e. all shaft speeds) based on applied constraints.
A gear set consists of Ring Gear, Planet Gear, Sun Gear. The sick diagram is the...
Unless you regularly park in San Francisco with your car pointing up or down a hill. Just put it on when the vehicle is stopped and don't worry about it.
Not read the article properly, but it's not really outside the box anymore. ;)
It's effectively a P1 hybrid architecture.
Can replace the starter, but not the alternator. As you keep the high voltage and low voltage systems separate.
It'd be a bit silly to call it a stator if it never operated in a fixed stated.
It sits on a one way clutch that is grounded to the transmisson case via a splined sleeve.
A torque converter has a stator that redirects the flow. This is the stationary element in the circuit.
The stator is housed on a one way clutch so it only reacts when there is a speed differential between the pump and the turbine.
It amplifies torque at the expense of speed.
Maximum torque...
Got to be careful about making sweeping statements. A system can be conceptualized that could yield an overall benefit. OP's statement about putting a system on the inside of the car is part that makes it interesting.
In the same way that a cars can control cooling vents. Open when needed...
I think you are missing the point of the OP's question. It's one of concepts, not systems of units. He's not confused because he's getting the wrong numerical answer because he's using rpm and not rad/s. He's asking where that torque comes from.
He should have used P ∝ Tw or P = k.Tw
My point...
An engine power thread that might not descend into a pile of nonsense.
The question is how do these components produce any torque/power measured?
I think OP is being conceptual making ∝ more appropriate. One might pedantically argue that he never stated the units of torque or power he...
22Hz is firing frequency at 900rpm. AC increases engine load. So this could very well be normal. Really impossible to tell without actually hearing it.
Well first of all. How do you work? What is your current procedure?
If you are the sole engineer and you realize that you are running into challenges, it would highlight that training is needed. Design for assembly, interface analysis etc.
Would you care to elaborate how it would have saved time? What issue would it have discounted? Would weighing vs calculating the inertia of a system miss any particular issues? It's not really answering the question of why you think calculating the inertia of the system is a waste of time.