AutoCAD inventor as CFD software

mech-eng
Messages
825
Reaction score
13
Can Autocad inventor be used as a cfd software such as ansys fluent?

Thank you.
 
Engineering news on Phys.org
Possibly in some limited form, but it is not going to work nearly as well as actual cfd software.
 

Thread 'Bubble formation in 4 mm gap vessel'

How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
View full post »
Thread 'Calculate minimum RPM to self-balance a CMG on two legs'

Thread 'Calculate minimum RPM to self-balance a CMG on two legs'

Here is a photo of a rough drawing of my apparatus that I have built many times and works. I would like to have a formula to give me the RPM necessary for the gyroscope to balance itself on the two legs (screws). I asked Claude to give me a formula and it gave me the following: Let me calculate the required RPM foreffective stabilization. I'll use the principles of gyroscopicprecession and the moment of inertia. First, let's calculate the keyparameters: 1. Moment of inertia of...
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Similar threads

Beginner's approach to CFD software?
Replies
8
Views
3K
Overlapping geometry in ANSYS fluent
Replies
1
Views
15K
What is the best factory layout software for importing Autocad drawings?
Replies
1
Views
965
Calculate the max speed at which a submarine rises/dives
Replies
5
Views
2K
Automotive Design and Simulation of a four stroke Otto engine
Replies
5
Views
2K
What is the Residual in Computational Fluid Dynamics?
Replies
4
Views
3K
CFD Modeling of Flue Gas Pollution Dispersion
Replies
1
Views
2K
How to combine two lines in one in mechanical sketches
Replies
6
Views
2K
Basic fountain design - recommendations
Replies
2
Views
2K
What Is the Correct Non-Dimensional Time Scaling in CFD for 2D Channel Flow?
Replies
2
Views
2K

Hot Threads

Recent Insights

Back
Top