Capacitor in a switching circuit

  • Topic: Engineering 
  • Thread starter nothing909
  • Start date
  • Tags Tags
    Capacitor Circuit
1 reply · 2K views · last reply
nothing909
Messages
168
Reaction score
4
Homework Statement
This is a switching circuit for a switched reluctance motor. At the right hand side of the circuit attached below, there's a 47μF capacitor. What is the need for that?

The attempt at a solution
Is it to reduce harmonics or ripple, or something of the sort?
 
Attachments
  • Schematic of a motor drive circuit: a 5V-driven transistor switches an optocoupler (TLP 251) with a 470 Ω resistor, feeding a buffer and totem-pole output stage that drives an IGBT (STGP6NC60HD) through a 560 Ω resistor. The IGBT switches a motor and diode across a 12V rail, with a 47 μF capacitor on the 12V line to ground.
    Circuit.png
    14.6 KB · Views: 483
nothing909 said:
Is it to reduce harmonics or ripple, or something of the sort?
Something like that. It's meant to keep switching noise and voltage dips due to sudden high-current changes in a load out of the power supply and other circuits. Usually there should be another smaller capacitor in parallel with it since the larger valued capacitors like 47 μF are usually electrolytics and have practical characteristics that are better at lower frequencies. A small non-electrolytic in parallel will deal better with high frequency noise. Look up "decoupling capacitor".