Cheap Homeade Solar Powered Phone Charger

  • Thread starter Thread starter nst.john
  • Start date Start date
  • Tags Tags
    Charger Solar
AI Thread Summary
To build a homemade solar-powered phone charger, a 5W solar panel is recommended for portability. A 5 Volt regulator is essential to convert the DC output from the solar panel to the appropriate voltage for charging a phone. This setup ensures that the charger is efficient and safe for use with mobile devices. Assembling these components will allow for effective charging while camping. Proper planning and component selection are key to a successful solar charger project.
nst.john
Messages
163
Reaction score
1
I would like to build a small solar powered phone charger for when I go up to camp soon, I was planning on using a solar cell and I was wondering what I need to assemble a solar powered phone charger. Can someone help?
 
Engineering news on Phys.org
I would google around for a 5W solar panel, nothing bigger than that really otherwise the panels might get to large to camp with. Since solar panels output DC you will need to place in a 5 Volt regulator between the panel and your phone (assuming your battery is rated at 5V). Then the output of that regulator should be enough to charge your phone.
 

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

How to measure solar panel voltage using arduino?
Replies
32
Views
4K
Charging an iphone with macbook charger
Replies
2
Views
1K
Switching between parallel and series connections (solar)
Replies
31
Views
4K
Isolate solar charger PWM pulses
Replies
10
Views
2K
Mimicking a 14.4VDC Speaker Charger
Replies
2
Views
1K
Power Your Bug Zapper with Solar: 12V DC to 12V AC Conversion Guide
Replies
38
Views
6K
Why do phone chargers cause radio interference?
Replies
14
Views
6K
Shopping advice: Solar battery charger and power supply
Replies
5
Views
2K
Manually charging batteries
Replies
11
Views
2K
How Can I Efficiently Build a Solar Phone Charger with Nimh and Lipo Batteries?
Replies
5
Views
2K

Hot Threads

Recent Insights

Back
Top