Cross-flow Heat Exchanger 2 phase calculation

Join the discussion
Registration is free. Ask a follow-up in this thread, or start your own.
5 replies · 2K views
cheetahunter
Messages
3
Reaction score
0
Hi all!
I'm working on a project of heating water from exhaust gases of kamin's chimney.
I have a cross flow heat exchanger (see pdf).
we have done calculations of heat transfer rate and the outlet temerature of the water, and got 150C.
so it probably gets boiled somewhere inside the HX. I need to do further calculation which will consider 2 phases of the water and new outlet water temperautre and heat transfer rate.
Does anyone can give me a direction?
 

Attachments

Physics news on Phys.org
I have used the e-ntu method. I have assumed that the water remains liquid (single phase) but then I got that the outlet temperature of the water reaches 150C .
I am trying to heat the water, and to transfer as much heat as possible.
I need to get atleast a range of outlet water temp's, but accurate answer will be great also
 
cheetahunter said:
I have used the e-ntu method. I have assumed that the water remains liquid (single phase) but then I got that the outlet temperature of the water reaches 150C .
I am trying to heat the water, and to transfer as much heat as possible.
I need to get atleast a range of outlet water temp's, but accurate answer will be great also
Is the pressure 1 atm (roughly)?

Chet
 
So, if the pressure is 1 atm., what is the temperature of the liquid/gas mixture once it starts boiling? So, recalculate the heat exchanger, for the part of the tubing up to this temperature, and find the corresponding length. Then recalculate the remainder of the heat exchanger holding the temperature fixed at this value. But, if all the water boils away before the end of the tube, you also need to consider a third section in which the water vapor is superheated.

Chet