Finding the Critical Velocity for Special Relativity Effects

AI Thread Summary
To find the velocity (v) at which Gamma (G) equals 1.0100, the correct formula for Gamma is essential, which is expressed as γ = (1 / √(1 - v²/c²)). The discussion highlights a common confusion regarding the exponent in the formula, clarifying that it should be 1/2 rather than 2. Participants suggest simplifying the equation by squaring both sides to isolate v. Ultimately, the conversation emphasizes the importance of correctly applying the definitions and equations in special relativity to solve the problem effectively.
scurry18
Messages
12
Reaction score
1

Homework Statement


For what value of v does Gamma (G) =1.0100? Observe that for speeds lower than this value, time dilationand length contraction are effects amounting to less that 1%


Homework Equations


L=Lp/G=Lp(1-(v^2/c^2))^2


The Attempt at a Solution


I do not know where to start. Is this the correct formula, and then if it is, how would I go about solving for the Velocity?
 
  • Like
Likes mishelly
Physics news on Phys.org
You seem to have the wrong expression for gamma, unless it's a typo.
 
The exponent on the right should be 1/2 (square root), not 2. Start with

\frac{L_p}{\gamma} = L_p \sqrt{1 - v^2 / c^2}

What can you do to simplify this equation a bit, first?
 
Why involve any lengths here? You have an equation (rather a definition) for Gamma do you not? Isn't it just

\gamma=\left( \frac{1}{1-\frac{v^2}{c^2}} \right)^{\frac{1}{2}}

If so, try squaring both sides of the equation.
 
I got it! Thank you!
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Back
Top