Geared transmission system question

  • Topic: Engineering 
  • Thread starter jojosg
  • Start date
0 replies · 51 views
jojosg
Messages
40
Reaction score
5
Homework Statement
The following figure shows a geared transmission system, in order to minimize the axial force on shaft II, please (1) determine the hand of helical gears; (2) determine the revolution direction of worm gear and its hand; (3) draw the three force components on helical gear 2, bevel gear 4 and worm gear 6.
Relevant Equations
For helical gears:
Axial force direction rule: Right-hand rule for right-hand helix, left-hand rule for left-hand helix.
To minimize total axial force on a shaft: the axial thrust from helical gear 2 must oppose the axial thrust from bevel gear 4.

Bevel gear axial force always points **toward the large end of the bevel gear**.

Worm drive: Worm axial force = worm gear tangential force; worm tangential force = worm gear axial force. Handedness and rotation direction follow the right/left-hand screw rule.
Screenshot 2026-11-19 195403.webp

  1. Helical gear hand selection:Motor rotates gear 1 downward on its right side as drawn.Bevel gear 4 on shaft II has its axial force pointing to the left (toward the cone apex / large end).To cancel this axial force, helical gear 2’s axial force must point to the right.If gear 2 axial force points right, gear 2 is right-hand, and mating gear 1 is left-hand.
  2. Worm (gear 5) hand and rotation direction:Bevel gear 4 drives bevel gear 5, so shaft III rotates downward when viewed from the top.We want worm 5 axial force to be consistent, and the worm must be right-hand.Worm rotation direction: counterclockwise when viewed from the top of shaft III.
  3. Force components summary (this is where I am unsure):
  • Helical gear 2: [itex]F_t[/itex] tangent opposite rotation, [itex]F_r[/itex] radially inward, [itex]F_a[/itex] to the right (to oppose bevel gear axial force).
  • Bevel gear 4: [itex]F_t[/itex] tangent, [itex]F_r[/itex] radially inward, [itex]F_a[/itex] toward the large end (to the left).
  • Worm gear 6: [itex]F_t[/itex] tangent, [itex]F_r[/itex] radially inward, [itex]F_a[/itex] opposite to the worm tangential force.
My uncertainty:I am not fully confident about the direction of the bevel gear axial thrust and the matching handedness of the helical pair to cancel forces on shaft II. Also I am not sure about the worm rotation direction and handedness selection. Could someone check the logic for minimizing the net axial force on shaft II and verify the force directions?
Image generation help (1).webp