Gradient at roller and pin support

4 replies · 3K views · last reply
chetzread
Messages
798
Reaction score
1

Homework Statement


in the notes , why did the author only stated that zero displacement occur at pin and roller support?
Why the author didnt stated that the slope at pin and roller support is also = 0 ?

Homework Equations

The Attempt at a Solution


As we can see from the figure, the gradient at pin and roller support = 0 ?
 
Attachments
  • Printed textbook page, chapter 4 'Deformation of Statically Determinate Structure', with a diagram of a simply supported beam under a uniform downward load w, showing its deflected elastic curve, labelled y = ? and θ = ?, with supports A (pin) and B (roller).
    329.jpg
    31.9 KB · Views: 561
The slope is maximum at the ends of the beam, where the pin and roller are located, not zero.
 
  • Like
Likes   Reactions: chetzread
David Lewis said:
The slope is maximum at the ends of the beam, where the pin and roller are located, not zero.
why not = 0?
 
David Lewis said:
The slope is maximum at the ends of the beam, where the pin and roller are located, not zero.
the slope is minimum in the middle of the beam, and 0 at the 2ends of beam, right?
 
The beam is sagging. Slope is zero only at the center of the beam. But at either end, slope is maximum.