How to Fix SSR Card Error in MCNP Using RSSA File?

  • Thread starter Thread starter TTA
  • Start date Start date
  • Tags Tags
    Mcnp
AI Thread Summary
The discussion revolves around an error encountered when using the SSR card after creating a WSSA file and renaming it to RSSA. Users report receiving an "unexpected eof on file rssa" error during processing. There is a call for suggestions on how to resolve this issue, but no solutions have been provided in the thread. One user indicates they are experiencing the same error and seeks assistance. The thread highlights a lack of recent engagement from knowledgeable users, as one participant has not been active for four years.
TTA
Messages
1
Reaction score
0
Dear all,
I have a problem related to SSR card.
I created a WSSA file (>1GB) from the input file by SSW card. I change the file name to RSSA in order to use for SSR card.
When I run SSR card, I got the the error: bad trouble in subroutine issrc of imcn unexpected eof on file rssa
How to fix the problem?
Any suggestion will be appreciated.
Thank you.
 
TTA said:
Dear all,
I have a problem related to SSR card.
I created a WSSA file (>1GB) from the input file by SSW card. I change the file name to RSSA in order to use for SSR card.
When I run SSR card, I got the the error: bad trouble in subroutine issrc of imcn unexpected eof on file rssa
How to fix the problem?
Any suggestion will be appreciated.
Thank you.
Dear TTA
I am facing the same error . Did you know how to fix the problem?
Thank s
 
TTA's last visit was 4 years ago.
 

Thread 'MCNP6 BURN Card Issue: Zero Burnup for Material in Fuel Assembly'

Hello everyone, I am currently working on a burnup calculation for a fuel assembly with repeated geometric structures using MCNP6. I have defined two materials (Material 1 and Material 2) which are actually the same material but located in different positions. However, after running the calculation with the BURN card, I am encountering an issue where all burnup information（power fraction(Initial input is 1,but output file is 0), burnup, mass, etc.） for Material 2 is zero, while Material 1...
View full post »

Similar threads

Why is my SSW/SSR code not producing readable output from a KCODE run?
Replies
3
Views
2K
How to use mdata file data output by mesh card in mcnp software?
Replies
1
Views
2K
MCNPX pwr pin depletion input file running error
Replies
15
Views
2K
MCNP6: error -- "bad trouble in imcn" is usually tangled with spacing error?
Replies
6
Views
4K
LCS error: bert.3 bert.2 when running BURN card MCNP
Replies
4
Views
2K
MCNP5 tallies conversion and MCNPX
Replies
1
Views
2K
How to finally run an input file via VISED/MCNP5 without error?
Replies
1
Views
3K
Chg_mem error problem with MCNP
Replies
6
Views
3K
MCNP lattice of the fuel assembly input file?
Replies
10
Views
3K
Geometry error in newcel
Replies
8
Views
1K

Hot Threads

Recent Insights

Back
Top