How to wire a 3-phase contactor for simple on/off switching

3 replies · 3K views · last reply
Nikhil N
Messages
80
Reaction score
2
I am first time using a contactor. I have a 3-phase contactor with me, Need to switch on and off without any load connected. It has two auxiliary terminals A1 and A2, for just to turn on how it should be connected?
Photo of an ABB A9-30-10 three-pole contactor, grey housing with blue and white markings, showing terminals labelled 1/L1, 3/L2, 5/L3 at top and 2/T1, 4/T2, 6/T3 at bottom, and coil terminals A1 and A2.

Wiring diagram of a contactor with a 110V AC supply arrow feeding into its coil terminals labelled A1 and A2.
 
Attachments
  • Wiring sketch of a contactor coil with terminals A1 and A2, with a line from A1 and A2 leading to a labelled 110V AC supply arrow at the top left.
    contactor.png
    1.4 KB · Views: 642
Nikhil N said:
I am first time using a contactor. I have a 3-phase contactor with me, Need to switch on and off without any load connected. It has two auxiliary terminals A1 and A2, for just to turn on how it should be connected?
you haven't told us the make and model ... we cannot help unless you supply the information

google the datasheet and post a link to it
 
Auxillary contacts are typically not meant to switch the load. They are a set of contacts meant to connect with control circuit wiring.
 
When all else fails read the directions.
 
  • Like
Likes   Reactions: NTL2009