Import Proteus Schematic to Orcad for PCB Layout

[nadinemaalouf]

hello,
how can i import the schematic (.dsn file) from proteus, and use it in orcad?
thanks for your answers

 

[moe_3_moe]

i think u can't ... but i am not sure u should use the capture cis...try it

 

[moe_3_moe]

hi nadine ... i was studying pcb circuits and how to make them at home.but i stopped on the capture cis only and didn't continue the layout so i sent an email to my dr. at the university and hope he is going to respond soon...(by the way r u lebanese?)

 

[albsher]

hi nadine i work before on layout of orcad , so if u want to make out of circuit u only to make schematic for the circuit then make mnl file from schematic then brouwse from layout for this file then run it, it will make the pcp design , there are some specification done for the size components used will ask u before it implement the design

 

[nadinemaalouf]

i will try that
thank you