Low Voltage Distribution Board ( TGBT )

  • Thread starter Thread starter DeathstrokeDMX
  • Start date Start date
AI Thread Summary
The discussion centers on the requirements for a Low Voltage Distribution Board (TGBT) for a specific installation involving multiple cooling chambers, a residential building, and outdoor lighting. The setup includes a 630kVA power transformer supplying various circuits, including main and individual circuit breakers for each component. Participants emphasize the importance of having a qualified electrician or electrical engineer handle the installation due to safety and liability concerns. The thread concludes with a note that assistance cannot be provided in this context. Proper expertise is essential for ensuring compliance and safety in electrical installations.
DeathstrokeDMX
Messages
1
Reaction score
0
Hi, can any one help me with this Low Voltage Distribution Board?
My installation a below :

17 Cooling Chamber
01 Residential building
01 Emplyees Small-Camp
20 Outdoor lamps
01 Water Submersible pump
02 Spares

All theses are supplied from Power Transformer 630kVA - 30kV/400V ( 3P+N )
This distribution board should contains :
01 Main circuit breaker
17 Circuits breakers for each chamber ( 23kW - 62kW / 40A - 105A )
01 Circuit breaker for Residential building ( 2 Floor Standard residential building )
01 Circuit breaker for Employees Small-Camp ( 4 Room, 1 Kitchen, 4 Air Conditioners )
01 Circuit breaker for 20 X Outdoor lamps ( 150W )
01 Circuit breaker for Water Submersible pump ( 6kW )
02 Circuit breakers for Spares
 
Engineering news on Phys.org
Due to liability concerns, we cannot help you. This needs at least a qualified electrician, and possibly an electrical engineer. This thread is closed.
 
  • Like
Likes davenn

Thread '3-terminal device external modeling'

Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...
View full post »
Thread 'Weird near-field phenomenon I get in my EM simulation'

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
View full post »

Hot Threads

Recent Insights

Back
Top