Op amp circuit to convert input currents to voltage output

7 replies · 2K views · last reply
gfd43tg
Gold Member
Messages
949
Reaction score
48

Homework Statement


Design a circuit containing a single op amp that can perform the following operation: Vo = 3*10^4(i2-i1), where i2 and i1 are input current sources


Homework Equations





The Attempt at a Solution


Where I'm at right now, I am just using the equation for a difference amplifier gains, but I have more unknowns than equations, so I don't know what to do.
 
Attachments
Hi Maylis. Could I suggest that you post images as unadorned jpeg (or png, etc) files, so those using basic tablets (and costly data plans) are still able to participate?
 
Alright, here is a .png
 
Attachments
  • Handwritten op amp circuit analysis: a schematic with resistors R1, R2, R3, R4 and RL, sources V1 and V2, and output V0, followed by derivation lines for V0 in terms of V1, V2, i1 and i2 and the value R2 = 3 x 10^4.
    5.7 attempt 1.jpg
    10.5 KB · Views: 520
Your diagram labeling does not agree with your equations.

Big hint: since the inputs are current you need a total of only 2 resistors.
 
Oh I see, I need to change the label of R2 and R3. Either way my problem persists. The equation should be correct now with that change, as well as making it R3*i2 in my second stop
 
Last edited:
Okay, I source transformed, corrected the labeling, and this is what I came up with.

Edit: my bad, I was saying that no current goes through R1 and R3, which can't be possible since there is a potential difference between Vn/Vp and the resistors. Now the equations are even messier. Where do you get the fact that I only need 2 resistors from? I am following the template for a difference amplifier as given in the textbook and I redrew as my original image, pre-source transform
 
Attachments
  • Handwritten work on paper: top, a circuit with two voltage sources, resistors and an op amp with feedback resistor and load; below, a source-transformed version with current sources, labeled Vp = i2 R4 and Vn - Vo over R2 = i1, followed by i2 R4 - i1 R2 = Vo, R4 = 3 x 10^4, R2 = 3 x 10^4.
    5.7 attempt 2.jpg
    10.8 KB · Views: 503
  • Handwritten op amp circuit with resistors R1, R2, R3, R4, RL, voltage sources V1 and V2, and output V0, followed by handwritten nodal equations.
    5.7 attempt 3.jpg
    11.6 KB · Views: 471
Last edited:
NascentOxygen said:
See if you can get it to work without R1 and R3.

And RL.


And BTW the pdf file is a lot easier to read, for me anyway.

If the new tablets, iPads etc etc can't even read pdf files any more I am more po'd than ever that xp is disappearing ... we are dumbing-down at an ever-increasing rate ...