R1 350 Ohms: What Current Flows at 50V?

  • Thread starter Thread starter x^2
  • Start date Start date
  • Tags Tags
    Bridge Resistor
Click For Summary
SUMMARY

The discussion centers on calculating the current through a resistor R1 (350 Ohms) when a voltage of 50V is applied. The participants concluded that with equal resistors in the circuit, the voltage across R1 is effectively 25V on each terminal, resulting in no net voltage and thus no current flow (0 A). The initial confusion stemmed from a misunderstanding of potential differences across the resistor.

PREREQUISITES
  • Understanding of Ohm's Law (V = IR)
  • Basic knowledge of series and parallel resistor circuits
  • Familiarity with voltage division in electrical circuits
  • Ability to analyze circuit diagrams
NEXT STEPS
  • Study voltage division in series circuits
  • Learn about parallel resistor configurations and their effects on voltage
  • Explore practical applications of Ohm's Law in circuit analysis
  • Review common mistakes in calculating current and voltage in circuits
USEFUL FOR

Students in electrical engineering, hobbyists working with circuits, and anyone seeking to understand current flow in resistor networks.

x^2
Messages
19
Reaction score
1

Homework Statement


What current flows through resistor R1 (350 Ohms) in the figure when the applied voltage is 50 V?
prob03a_circ_comp_resis.gif


Homework Equations



V = IR ?

The Attempt at a Solution



I would have thought the answer would be zero because I thought the potential at R1 is equal (but this was incorrect). What am I missing here? I guess I don't see how the potential at this point isn't equal, and I'm not sure how to solve it now knowing that it must not be the same.

x^2
 
Last edited:
Physics news on Phys.org
x^2 said:
I would have thought the answer would be zero because I thought the potential at R1 is equal (but this was incorrect). What am I missing here? I guess I don't see how the potential at this point isn't equal, and I'm not sure how to solve it now knowing that it must not be the same.

x^2

If the other R's are equal, then it is 0.

With 50V applied to AB, the terminals of each side of R1 would be 25V. No net voltage, no current.
 
LowlyPion said:
If the other R's are equal, then it is 0.

With 50V applied to AB, the terminals of each side of R1 would be 25V. No net voltage, no current.

That's what I thought... I tried 0 A but it was incorrect. I'm going to talk to the prof. and see what is wrong.

Thanks!
x^2
 
x^2 said:
That's what I thought... I tried 0 A but it was incorrect. I'm going to talk to the prof. and see what is wrong.

Thanks!
x^2

The correct answer is 0 A. There was a problem with the system which was why I was getting it wrong.

Thanks for the confirmation!
x^2
 

Similar threads

Replies
2
Views
929
  • · Replies 4 ·
Replies
4
Views
2K
  • · Replies 4 ·
Replies
4
Views
2K
  • · Replies 6 ·
Replies
6
Views
2K
  • · Replies 7 ·
Replies
7
Views
3K
  • · Replies 5 ·
Replies
5
Views
2K
  • · Replies 3 ·
Replies
3
Views
2K
  • · Replies 3 ·
Replies
3
Views
3K
Replies
4
Views
2K
  • · Replies 3 ·
Replies
3
Views
2K