Time division multiplexing for analogue signal

AI Thread Summary
The discussion centers on the implementation of Time Division Multiplexing (TDM) for an upconverted 1 GHz signal in an OFDM system. The initial response suggests that while TDM can be applied, it may not be scientifically sound as it creates a new spectrum. The user clarifies that GMSK is a digital modulation technique, and their focus is on analog signals after upconversion. They inquire about the feasibility of using Frequency Division Multiplexing (FDM) for signals at 1 GHz and 1.2 GHz. The conversation highlights the complexities of multiplexing techniques in the context of analog signal processing.
thavamaran
Messages
39
Reaction score
0
Hi guys, I am designing an OFDM system and then upconverted at 1 GHz. Now I have an idea of implementing TDM for this 1 GHz signal.

Is it possible, please explain from theoretical point of view and if possible, please help from MATLAB perspective.

Thank you very much,
 
Engineering news on Phys.org
i think that if you mean by TDM gsm system "for example" then its easy.
but not good from science point of view as you have just created new spectrum for gsm or ay TDM system.
any way in MATLAB use acarrier and multiply it with your modulated data by GMSK.
good luck
 
Hi there, thanks for your reply. But GMSK is for digital modulation. After upconverting my signal to 1 GHz, it will be analogue then.

For an instance, say I have a signal with carrier frequency of 1 GHz and 1.2 GHz, can I use FDM to multiplex them?

Thank you!
 
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
Thread 'How Does Jaguar's 1980s V12 Dual Coil Ignition System Enhance Spark Strength?'
I have come across a dual coil ignition system as used by Jaguar on their V12 in the 1980's. It uses two ignition coils with their primary windings wired in parallel. The primary coil has its secondary winding wired to the distributor and then to the spark plugs as is standard practice. However, the auxiliary coil has it secondary winding output sealed off. The purpose of the system was to provide a stronger spark to the plugs, always a difficult task with the very short dwell time of a...
Back
Top