Touch lamp circuit with TT6061 IC schematic

3 replies · 3K views · last reply
Guineafowl
Messages
971
Reaction score
422
As part of troubleshooting this circuit I drew a full schematic, only to find near the end that the blob chip was blown - the crack was hiding behind a capacitor. Anyway, since I went to the bother, I thought I'd post the schematic here in case it helps anyone else...

I think the IC is a TT6061.
Hand-drawn schematic of a touch lamp circuit with a central IC block labelled IC and pins numbered 1 to 8, a touch plate at the bottom left, a triac TT1 driving a lamp at top right, and labelled components R1 to R9, C1 to C6, L1, D1 to D3 and ZD1.
 
jim hardy said:
tt6061 datasheet, of sorts..

http://www.micropik.com/PDF/tt6061a.pdf
Might be useful to someone some day. I was almost glad the touch board was blown - I wasn't too keen on the board always being active and waiting for a touch. R1 would get quite warm even when the lamp was off.

A bit like those socket outlets with permanently-wired USB supplies. Not my cup of tea.

The lamp has been reincarnated as a normal lamp, with proper earthing and an inline switch.
 
Guineafowl said:
The lamp has been reincarnated as a normal lamp, with proper earthing and an inline switch.
That's interesting. I have several table lamps to which I've added touch sensor modules . Local Ace hardware store carries one that fits nicely in the base. Great for when I'm stumbling around in the dark.

Ahh well - did not Jimmy Buffet say 'if we weren't all different we'd all be the same ?
 
  • Like
Likes   Reactions: NascentOxygen and Guineafowl