Why Do Low Frequencies Travel Through Walls?

  • Thread starter Thread starter BigMacnFries
  • Start date Start date
AI Thread Summary
Low-frequency sounds, such as bass around 75 Hz, travel more effectively through walls and obstacles due to their longer wavelengths, which can bend around barriers. In contrast, higher frequencies, like those around 750 Hz, have shorter wavelengths that are more easily blocked. This phenomenon is known as diffraction, which occurs when the wavelength is large compared to the size of obstacles. Additionally, sound transmission can vary based on the material and resonance of walls and windows, with windows often allowing more sound to pass through. Overall, the annoyance from low-frequency noise is exacerbated by the physical properties of sound waves and the construction of the home.
BigMacnFries
After being pissed by my neighbours bass all afternoon I am wondered why is it that only the low frequencies travel into my room while the treble is completley inaudible?
 
Physics news on Phys.org
Waves at low frequencies have a larger wavelength. Typically, low noises are roughly at ~75 Hz, the speed of sound is about 340 m/s, so that gives a wavelength of \lambda = v/f=340/75 \approx 4.5 m. Since this is much larger than the typical dimensions of the obstructions the waves meet, it will 'bend around it'.

Higher notes, at a frequency of about 750 Hz, which is 10 times higher, have a wavelength taht is 10 times shorter ~45 cm. Waves at these frequencies are more easiliy blocked.
 
"bend around it", please explain, as I am inside a closed house so sound must travel through the walls.
 
It's called diffraction. I found a site about it:
http://hyperphysics.phy-astr.gsu.edu/hbase/sound/diffrac.html

Diffraction will only occur if the wavelength is large compared to the size of the obstacles.

Even though your house is closed, the sound will be transmitted through the windows much easier than through the walls. This too might be frequency dependant due to the resonance frequencies of the windows and walls, but I`m not too sure about that.
 
You can tell if the walls and windows are resonant with the frequency from your neighbours bass because they will rattle and shake quite noticably. In fact the rattling and shaking at my house is more annoying than the actual music.

I too have loud neigbours :smile: .

Claude.
 
Is that somewhat similar to the resonance when you place two tuning forks beside each other and make one vibrate
 
no - that's either forced or the 2 tuning forks have the same natural frequency. But think about it, those idiots, that spend thousands on sound systems, aren't even benefitting from it - what kind of rice burner has ANY 4.5 meter span, let alone one, from the front of the sub-woofer. The car is too small to even set up a wave in.
 
Cab Calcs

Automobile cab tuning frequencies are typical based on ¼ wavelengths not the full wavelength.
 
Claude Bile said:
I too have loud neigbours :smile: .

I have a bunch of Menonite (sp?) neighbors. Loudest noise is the occasional car starting up around here :D Except when some low rider or whatever jerk comes up the main street a few blocks away with their stupid base.
 
  • #10
The correct answer is that wave amplitudes are absorbed exponentially with distance
according to the wavenumber. If the wall is only 0.01 wavelengths thick, the sound
will get through much better than if it is .1 wavelengths thick.
 
  • #11
I agree with Antiphon, and I guess you can also think in terms of the cavity (room) resonances. In a cubic room of 5 meters you have \lambda = 68 m [\itex] which is pretty close to the wave length you are mentioning. Moreover this resonances tell us that the transmissivity of you walls get higher at these frequencies. You have also to consider how much energy is concentrated in each frequency of the music source, i.e. its spectrum.<br /> <br /> Best Regards<br /> <br /> DaTario
 
Back
Top