Can a thermoelectric cooler be used as a thermoelectric generator?

AI Thread Summary
Thermoelectric coolers can potentially be used as thermoelectric generators, but their efficiency is significantly lower than dedicated generators. Concerns arise regarding the impact of high temperatures on the coolers, despite their ratings suggesting they can handle it. The conversion process is reversible, but the inefficiency of thermoelectric coolers means they may not produce substantial electricity. The efficiency is ultimately limited by the Carnot efficiency, which depends on the temperature difference between the hot and cold sources. Overall, while using a cooler as a generator is feasible, it is unlikely to yield efficient energy conversion.
nu_hash
Messages
10
Reaction score
0
The title should be self explanatory, the only reason I ask this is because thermoelectric coolers are ridiculously cheap compared to a thermoelectric generator.

Is there anything I need to check when using a cooler as a generator, I am expecting temperatures on the cold to be around 20C and hot around 200C. Would high temperatures damage the coolers even though are rated high enough?
 
Engineering news on Phys.org
I am afraid the energy conversion is irreversible in the thermoelectric cooler. It is like as one cannot generate electricity by cooling a freon refrigerator.
 
i believe it is reversible
but inefficient

get one and give it a try.

the thermocouple effect works both ways

but any fans or active electronics will have to be dealt with separately.
 
Thermoelectric cooler is inefficient by itself. If a reverted action is possible, according to logics, the inefficient thermoel. cooler could be turned into an efficient electricity generator ?!
 
Last edited:
...efficient electricity generator ?!

a not very efficient one i would think.

It'd be of course limited by Carnot efficiency, difference between hot and cold sources.

A google search on 'thermo electric generator efficiency' took me to several outfits selling them. They're more practical than i thought.



http://www.tegpower.com/
electrochem.org
 
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Back
Top