- #1
CFDFEAGURU
- 783
- 10
Hello all,
Just thought I would throw this one out there.
Who preferes to use the RBE3 command to automatically create a set of constraint equations and who prefers to use the Contact Wizard?
I used to use the Contact Wizard but I recently got burned by it, so I switched to using the RBE3 command, which isn't the most pleasant command either but hey it's ANSYS.
Any thoughts would be appreciated.
Thanks
Mattt
Just thought I would throw this one out there.
Who preferes to use the RBE3 command to automatically create a set of constraint equations and who prefers to use the Contact Wizard?
I used to use the Contact Wizard but I recently got burned by it, so I switched to using the RBE3 command, which isn't the most pleasant command either but hey it's ANSYS.
Any thoughts would be appreciated.
Thanks
Mattt