- #1
DJT1967
- 3
- 0
Hi Guys I hope you can help. I’m currently trying to modify some existing equipment and have a problem that I hope you good people can help me solve. I have a fabricated bracket that currently supports another bracket than runs on linear bearings to position its self.
see attached JPG for rough layout.
We would like the existing bracket to support a load of approximately 1000kgs and after doing some research and found some calculations that would appear to be roughly what I need but I’m not sure.
I was wondering if anyone here would be so kind as to point me in the right direction as to what calculation / formula I would need to calculate the maximum load the bracket will take.
Thanks in advance for your help.
see attached JPG for rough layout.
We would like the existing bracket to support a load of approximately 1000kgs and after doing some research and found some calculations that would appear to be roughly what I need but I’m not sure.
I was wondering if anyone here would be so kind as to point me in the right direction as to what calculation / formula I would need to calculate the maximum load the bracket will take.
Thanks in advance for your help.