- #1
tiviny
- 21
- 0
I'm attempting to spin cast a parabola, and aim to hang my spinning vessel directly from the driveshaft of a motor to get it to spin as cleanly as possible.
Are there any PWM (12v ideally) 10-100rpm dc motors than could support 10kg thrust load?
I would strongly prefer to not use gear systems, but I suspect it may be ineviatable.
Also, could AC motors be used?
Thank you, Tom
Are there any PWM (12v ideally) 10-100rpm dc motors than could support 10kg thrust load?
I would strongly prefer to not use gear systems, but I suspect it may be ineviatable.
Also, could AC motors be used?
Thank you, Tom