- #1
Gughanath
- 118
- 0
I made a case for a alarm system using vacuum forming. How do I join the two halves of the case?
To join a vacuum formed alarm system case, you will need the following materials:
Before joining the plastic pieces, you will need to clean them with a solution of acetone and water to remove any dirt or oils. Then, use sandpaper to roughen the surfaces that will be joined. This will help the adhesive bond better to the plastic.
The best way to join the plastic pieces together is by using a hot glue gun. Apply a thin layer of hot glue along the edges of the pieces to be joined. Then, quickly press the pieces together and hold them in place until the glue sets. You can also use clamps or masking tape to hold the pieces together while the glue dries.
No, not all adhesives are suitable for joining plastic pieces. It is important to use a plastic adhesive specifically designed for joining plastic materials. Using the wrong type of adhesive can result in a weak bond or damage to the plastic.
If you want to reinforce the joint for added strength, you can mix a small amount of baking soda with the hot glue before applying it to the plastic pieces. This will create a stronger bond between the pieces. You can also use additional hot glue along the edges of the joint for added reinforcement.