- #1
Tomcat
- 5
- 0
Hello !
This is my first post on the Physics Forums. I am electronics technician employed in mass spectrometry laboratory at RBI Institute, Zagreb, Croatia.
My question is related to calibration of RTD sensors, which I must do in another lab or division, and since I developed prototype of RTD based neasuring device (based on 0.1%, class B RTD Pt100 sensor) there is possiblity that I need to make more of these. Is there possibility of construction of RTD calibrating equipment ? Is there reliable design of calibration device or cell which can be done, keeping in mind that I am working in chemistry lab but I am, regarding of expenses and equipment for this project, confined into my electronics work room.
Thank you !
Tom
This is my first post on the Physics Forums. I am electronics technician employed in mass spectrometry laboratory at RBI Institute, Zagreb, Croatia.
My question is related to calibration of RTD sensors, which I must do in another lab or division, and since I developed prototype of RTD based neasuring device (based on 0.1%, class B RTD Pt100 sensor) there is possiblity that I need to make more of these. Is there possibility of construction of RTD calibrating equipment ? Is there reliable design of calibration device or cell which can be done, keeping in mind that I am working in chemistry lab but I am, regarding of expenses and equipment for this project, confined into my electronics work room.
Thank you !
Tom