Designing a Trolley Hydraulic Jack: Need Help with Lifting Pad Layout

AI Thread Summary
The discussion focuses on designing a trolley hydraulic jack, specifically seeking guidance on the layout of the lifting pad. A suggestion is made to utilize a standard engineering 3-view drawing for clarity. Participants emphasize the importance of providing detailed information for more effective assistance. It is also noted that contributors will not create designs for the requester but will offer advice. Clear communication and detailed specifications are essential for successful design collaboration.
ezzo20
Messages
1
Reaction score
0
hi guys
am designing a trolley hydraulic jack .. am asked to do a lay out of the arm lifting the wieght ..

would you help me how to do good lay out of my lifting pad??
 
Engineering news on Phys.org

Thread 'Bubble formation in 4 mm gap vessel'

How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
View full post »
Thread 'What type of toilet do I have?'

Thread 'What type of toilet do I have?'

I was enrolled in an online plumbing course at Stratford University. My plumbing textbook lists four types of residential toilets: 1# upflush toilets 2# pressure assisted toilets 3# gravity-fed, rim jet toilets and 4# gravity-fed, siphon-jet toilets. I know my toilet is not an upflush toilet because my toilet is not below the sewage line, and my toilet does not have a grinder and a pump next to it to propel waste upwards. I am about 99% sure that my toilet is not a pressure assisted...
View full post »

Thread 'Thread No-Go plug gage allows 3 turns to enter. That's too many!'

After over 25 years of engineering, designing and analyzing bolted joints, I just learned this little fact. According to ASME B1.2, Gages and Gaging for Unified Inch Screw Threads: "The no-go gage should not pass over more than three complete turns when inserted into the internal thread of the product. " 3 turns seems like way to much. I have some really critical nuts that are of standard geometry (5/8"-11 UNC 3B) and have about 4.5 threads when you account for the chamfers on either...
View full post »

Similar threads

Hydraulic Car Ramps...... need to make them go up and down
Replies
15
Views
4K
Linear actuator use in all electric mini-digger
Replies
9
Views
4K
Weight Transfer Formula?
Replies
9
Views
1K
Hydraulic winch torque questions
Replies
4
Views
4K
Design a 1000Kg Hydraulic Scissors Lift
Replies
10
Views
5K
Trying to determine linear actuator force needed
Replies
20
Views
3K
Stress Analysis of Lifting Plate With Bail
Replies
1
Views
2K
RTG crane -- hydraulic motor and linkage design to turn these wheels
Replies
13
Views
3K
Calculating Force Needed to Raise Steel Tower
Replies
5
Views
3K
Raising a farm windmill tower
Replies
5
Views
2K

Hot Threads

Recent Insights

Back
Top