Sorry for my mix up with terminology,
yeh i understand the process of doing it but i don't know how i would do it in this scenario given that the poles are complex and I am looking for a sine or cos in the time domain response. Many thanks.
Sorry i didnt explain myself very well, say you have a system whos transfer function is;
H(s)= \frac{5}{s^2 + 4S + 5}
When the input is a step response, the output will be a decaying sinusoid before it reaches a steady state, I would like some help in understanding how you get to a time...
Yeh that is helpful thanks, i was wondering if anyone could explain it in terms of Laplace domain equations and time responses etc as that is what I am struggling with.
many thanks
Hi,
i'm having a bit of trouble understanding how a system modeled by a transfer function in the laplace domain with no zero's and a complex conjugate pair for the poles causes an oscillation when the unit step function is applied. Any help would be appreciated
Many thanks.
Sorry maybe i wasnt clear enough, i meant plotting the information from the the transfer function(i.e. the poles and zeros) onto the argand diagram. That bit is all understood.
I am just unsure about how to get from that argand diagram form to a frequency response.
Forget about the...
Hi I am after any information regarding zero pole plots, specifically with reference to filters.
I understand the process of getting the transfer function and plotting it. But once its been plotted how do you go about translating that into a frequency response.
I am also wondering about...
Homework Statement
Question attached
Homework Equations
Frequency response of circuit given in document
The Attempt at a Solution
The question leads me to find the Gain and phase of the gain, pole and zero terms.
The breakpoint frequency and the point where the gain term is 0db...
Hi I'm having some problems with using the graphical method to determine the output characteristics, the question and the answer are all included in the document attached. I understand the process of putting the load line on the graph but for this application i have no idea what to do.
Many...
EDIT: I was being stupid and forgot the first diode would turn off after i worked out stuff for diode C, thanks anyway, solution found!Hi I'm having some trouble getting the correct output voltage when i model the diodes using a voltage ofset and resistors.
A = 4V, B = 2V, C = 3V
Using Voltage...
I have the following equation below but i am unsure about the method of finding the variable C. Sorry if its hard to read.
1.41 = |(1+1.10iC)/(1+0.1iC)|
Many thanks