Recent content by Prasannak

1st of all calculate the acceleration acceleration can calculated by using equation of motion, aceeleration= 2ө/ (tXt) where ө= total angle travelled, (in your case it is 110 degrees) t= time taken for traveling the angle ө(in your case it is 10 sec.) torque, T= (inertia of...

http://www.engineersedge.com/gears/gear_toleances_fine_pitch.htm Please Check the above link... I wanted to know for what purpose u require this information. Is this for for any testing equipment?

Thanks for the reply... In this particular application, components are moving in that flapper. And this flapper is located in between the 2 conveyors.I can not able use the air jet for the reason that orientation of component may change or the speed of motion of component will increase. I have...

It depends. Basicaslly i am using this mechanism for rejecting the components flowing in a conveyor.

Hi All, I need a actuation system which will rotate the 80mmx100mmx4mm plate from 0-45 degrees, pivot point @ one end of the plate. I need the time for moving it to 45 degree and back to the original position will be 40 milli-seconds including the response time of the actuator. Here we can...

Thank U very muchhhh...

Thanks for the respons. Tube dia= 40mm, Maximum velocity= 30m/sec Principle of working of mass flow sensor: An electrically heated thermoresistor is kept at a constant higher temperature relative to the medium (CTD mode). The heat dissipation into the medium increases with the...

U can also calculate the forcce by using, F=PxA F=force applied P=Pressure of the air jet A=Area of the tube

can u attach the sectional view of the bearing arrangement, so that i can analyse the bearing arrangement..

http://www.roymech.co.uk/Useful_Tables/ISO_Tolerances/ISO_LIMITS.htm"

effect on Flow and pressure measuring due to turbulent flow of air Hi, I want to measure the air flow rate using a device which will basically measure the velocity of air and converts that in terms of flow rate reading. For creating flow of air i have used vacuum pumps which is connected by...