Lens Flare/Halo: Photographing in Vacuum - Effects

  • Thread starter Thread starter technobot
  • Start date Start date
  • Tags Tags
    Halo
AI Thread Summary
In a vacuum, photographing a bright light source would not produce a halo or lens flares due to the absence of atmospheric scattering and reflections from particles. Lens flares are primarily caused by the lens optics rather than external environmental factors. If lens distortions are neglected, the image would show only the bright light source itself without additional effects. However, human vision limitations, such as astigmatism, can affect perception of light sources. Therefore, in ideal conditions, one would only see the light without halos or flares.
technobot
Messages
29
Reaction score
0
I was wondering - if I were to photograph (or look at) a bright source of light in full vaccum, would I see a halo around the light source, or any other lense flares? If so, does it form purely due to the lense optics, or are there some other contributing effects?
 
Science news on Phys.org
Lens flares, as the name implies, are from the lens itself. There are other similar effects seen in the atmosphere due to reflection off dust and or water dropplets, refraction, etc.
 
ok, so if I neglect the lense distortions, and assume a vacuum (hence no scattering), then I should see no halo? Just the bright surface of the light itself?
 
Well, unless you have truly excellent vision (particularly no astigmatism), you can't trust your own eyes either.
 
I would like to use a pentaprism with some amount of magnification. The pentaprism will be used to reflect a real image at 90 degrees angle but I also want the reflected image to appear larger. The distance between the prism and the real image is about 70cm. The pentaprism has two reflecting sides (surfaces) with mirrored coating and two refracting sides. I understand that one of the four sides needs to be curved (spherical curvature) to achieve the magnification effect. But which of the...
Back
Top