Thermal Noise Voltage of 3 Resisors in Series

AI Thread Summary
The discussion focuses on the thermal noise voltage generated by three resistors connected in series. Thermal noise, also known as Johnson-Nyquist noise, is a fundamental phenomenon in resistors due to their temperature. The voltage noise can be calculated using the formula Vn = √(4kT/R), where k is Boltzmann's constant, T is the temperature in Kelvin, and R is the total resistance. The link provided offers additional insights and calculations related to this topic. Understanding thermal noise is crucial for designing low-noise electronic circuits.
bhanesh
Messages
9
Reaction score
0
What is thermal noise voltage of three resisors connected in series
 
Engineering news on Phys.org

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

Low-noise Amplifier for a sensitive radio receiver
Replies
4
Views
1K
Tuning a PID with extraneous noise on the error signal
Replies
13
Views
3K
Energy balance in noise cancelling headphones
Replies
7
Views
2K
Peltier cell in series both electrically and thermally
Replies
5
Views
2K
Ground loop on electronic audio systems
Replies
28
Views
729
Transistor radio amplifier noise in the 70s
Replies
14
Views
2K
Which type of capacitor has lower 1/f noise: MLCC or film?
Replies
3
Views
2K
Help with Tektronix differential probes
Replies
12
Views
2K
Noise voltage from t-network feedback in opamp circuit
Replies
1
Views
3K
Faraday disc voltage increase
Replies
3
Views
1K

Hot Threads

Recent Insights

Back
Top