Another Beginner Question (Interfacing Computer Hardware/Circuitry)

  • Thread starter Thread starter Ulnarian
  • Start date Start date
  • Tags Tags
    Beginner Computer
AI Thread Summary
Building a timer resembling an old-school flip clock is feasible for beginners, but using a Commodore 64 may present limitations due to its outdated hardware. Connecting a 555 timer to a flip clock motor is a good start, but the reset function needs careful planning. To enable the computer to reset the timer based on user input, specialized software or a more modern platform like Arduino or Raspberry Pi is recommended. These platforms offer greater flexibility and resources for interfacing with hardware. Exploring hobby forums and documentation related to Arduino or Raspberry Pi will provide valuable guidance for this project.
Ulnarian
Messages
27
Reaction score
0
So, I want to build a timer in the style of an old-school flip clock (like this http://www.ladidah.com.au/range/images/flip-clock-grey.jpg) that counts from 000:00 minutes to 108:00 minutes. Whenever a user enters a certain sequence of numbers on the computer, the timer should reset itself to 000:00.

I'm brand new to electronic projects. I reckon I can connect the output of a 555 to a flip clock motor and calibrate the gear train appropriately (haven't quite worked out the reset function yet). The thing I am not sure about is how to get my computer to directly affect the circuitry (i.e. reset the timer after the sequence is entered). Does this require specialized software? I've got an old Commodore 64 laying about that I think would work pretty nicely.

Is this something that is feasible for a newbie? Is their any documentation out there I should be reading up on?

Thanks!
 
Engineering news on Phys.org
Sure that is feasible, but a Commodore 64 has limited hardware possibilities. A more modern Auduino or Rasberry PI computer can do it much easier. Visit the hobby forums for those and I'm sure you'll find examples of your kind of project.
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

  • Sticky
Getting Started With Computers and Programming
Replies
13
Views
7K

Hot Threads

Recent Insights

Back
Top