Calculating Energy Delivered by a Pacemaker

  • Thread starter Thread starter Sloan650
  • Start date Start date
AI Thread Summary
The discussion focuses on calculating the energy delivered by a pacemaker to the heart, using a resistance of 100 ohms, a pulse amplitude of 1.2 volts, and a pulse duration of 0.5 ms at a stimulation rate of 70 bpm. The initial calculation yields an energy delivery of 7.2 microjoules per pulse, leading to an average power output of 8.4 microwatts. There is confusion regarding the significance of the current drain of 2 microamps, which is clarified as related to battery consumption rather than affecting energy delivery calculations. The calculations confirm that the power formula used incorporates current, aligning with the values provided in the exam question. Overall, the discussion emphasizes the importance of distinguishing between energy delivered to the heart and current drain for battery life considerations.
Sloan650
Messages
12
Reaction score
0
A pacemaker stimulates heart tissue with R of 100ohms.
Pulse amplitude is 1.2 Volts & pulse duration is 0.5ms.
Stimulates at 70bpm
Current drain = 2microamps

Calculate energy delivered to heart from pacemaker at each pulse.

i got

P=V^2/R = 0.0144

Then Energy = Power*time = 0.0144*0.5x10-3 = 7.2x10-6 J

But do i not need to take into account the current drain?
 
Engineering news on Phys.org
power P = V X I

and since I = V/R,
then
P= V X (V/R) = V^2/R

so when you did V^2/R you included current.

the 2 microamps sounds more like battery drain to me.

7.2 microjoules 70 times a minute = 8.4 microwatts
at 2 microamps dictates least 4.2 volt battery?

anything corroborate here?
 
2µA - It is current drain due to the pacemaker circuitry.

Im a bit confused, its a past exam question.
 
all the values i gave were all that was given in the question.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
Thread 'Beauty of old electrical and measuring things, etc.'
Even as a kid, I saw beauty in old devices. That made me want to understand how they worked. I had lots of old things that I keep and now reviving. Old things need to work to see the beauty. Here's what I've done so far. Two views of the gadgets shelves and my small work space: Here's a close up look at the meters, gauges and other measuring things: This is what I think of as surface-mount electrical components and wiring. The components are very old and shows how...
Back
Top