Calculating Work: Uniform Chain on Table with Hanging Part - IIT 1985

AI Thread Summary
A uniform chain of length 'L' and mass 'M' has one-third of its length hanging off a smooth table. To calculate the work required to pull the hanging part onto the table, the center of mass of the hanging section, located at L/6 below the table, must be considered. The force needed to lift the hanging mass is mg/3, and the displacement is L/6. Using the work done against gravity formula, the correct calculation yields a total work of MgL/6. The final answer is confirmed to be MgL/6, correcting the initial miscalculation.
prateek_34gem
Messages
15
Reaction score
0

Homework Statement



Uniform chain of length 'L' and mass of 'M' is lying on smooth table and one third of it's length is hanging vertically down over the edge of the table. If 'g' is acceleration due to gravity , then work required to pull the hanging part onto the table is :

A)MgL
B)MgL/3
C)MgL/9
D)MgL/18
(I.I.T :- 1985)



The Attempt at a Solution



mass of hanging part will be m/3. so it will be exerting mg/3 force downward.
so this amount of force is required to pull it up.when the chain will be up its displacement along table will be l/3 because now hanging part is on table.
so

F=Mg3
S=L/3
Work = F*S= MgL/9

But it is the wrong answer.
 
Last edited:
Physics news on Phys.org
Try lifting the center of mass of the hanging chain up on to the table and using the formula (work done against gravity = m*g*h).

The center of mass is halfway down the part that's hanging off, which was L/3. So the center of mass is L/6 below the table top. The mass of the hanging part is 1/3 of the total mass...Go for it.
 
ya i got it . thnx a ton
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top