Conversion for maximum and minimum pressure in South African water reticulation

AI Thread Summary
The minimum pressure for water reticulation systems in South Africa is set at 24 meters, which translates to approximately 240 kPa. The maximum pressure allowed is 900 kPa. The discussion seeks assistance in converting these pressure measurements for a training manual for the waterworks department. The user is looking for the minimum pressure in kPa and the maximum pressure in terms of head. Accurate conversions are essential for effective water supply management.
dacgray
Messages
5
Reaction score
0
Hi

The minimum pressure acceptable in South African water reticulation systems is 24m.

The maximum pressure acceptable is 900 kPa.

http://www.mangaung.co.za/docs/Regulations-Water-Conservation.pdf

I need to write write a training manual for the waterworks department, and I need to know the minimum pressure in terms of kPa, and the maximum pressure in terms of head. Water is pulled from atmospheric pressure and supplied to users at at atmospheric pressure.

Could you please give me these pressures. Thanks a million!
 
Last edited by a moderator:
Physics news on Phys.org
Can anybody help me? :)
 

Thread 'Average velocity as a weighted mean'

Hello everyone, Consider the problem in which a car is told to travel at 30 km/h for L kilometers and then at 60 km/h for another L kilometers. Next, you are asked to determine the average speed. My question is: although we know that the average speed in this case is the harmonic mean of the two speeds, is it also possible to state that the average speed over this 2L-kilometer stretch can be obtained as a weighted average of the two speeds? Best regards, DaTario
View full post »

Thread '1:1 versus 2:1 Mechanical Advantage debate'

The rope is tied into the person (the load of 200 pounds) and the rope goes up from the person to a fixed pulley and back down to his hands. He hauls the rope to suspend himself in the air. What is the mechanical advantage of the system? The person will indeed only have to lift half of his body weight (roughly 100 pounds) because he now lessened the load by that same amount. This APPEARS to be a 2:1 because he can hold himself with half the force, but my question is: is that mechanical...
View full post »
Thread 'Beam on an inclined plane'

Thread 'Beam on an inclined plane'

Hello! I have a question regarding a beam on an inclined plane. I was considering a beam resting on two supports attached to an inclined plane. I was almost sure that the lower support must be more loaded. My imagination about this problem is shown in the picture below. Here is how I wrote the condition of equilibrium forces: $$ \begin{cases} F_{g\parallel}=F_{t1}+F_{t2}, \\ F_{g\perp}=F_{r1}+F_{r2} \end{cases}. $$ On the other hand...
View full post »

Similar threads

How can water pressure be measured in m
Replies
6
Views
15K
Force of pressurized water exiting a hose or pipe?
Replies
20
Views
10K
Pressure and velocity calculation for microchannel. pls help
Replies
2
Views
2K
Why is the U-2 nicknamed the Dragon Lady?
Replies
4
Views
8K
Current and Future AI Threats to Humanity and the Human Response
Replies
10
Views
4K
Civilization of millions of rings.
Replies
3
Views
4K
Schools PGRE - A message to undergrads from physics grad school.
Replies
25
Views
8K

Hot Threads

Recent Insights

Back
Top