Dielectric resonator - microwaves

AI Thread Summary
Recent research indicates that shining microwaves on a mixture of high dielectric constant solids and liquids significantly enhances the electromagnetic field in both components compared to pure liquids. The study attributes this effect to microwave scattering and improved penetration. While the findings are intriguing, there are questions about the underlying physics and potential analogies in existing applications. The phenomenon, particularly relevant at around 260 GHz, suggests that mixing dielectrics can lead to increased microwave confinement, although practical applications may be limited by the need for low temperatures and strong magnetic fields. Overall, the implications of this effect could extend to various fields beyond the specific experiment discussed.
max201
Messages
3
Reaction score
0
Hi,

recently there was an article in one scientific journal where they claimed that when microwaves are shined on a mixture of dielectric solid (powdered or crystalline) of high dielectric constant with some liquid, the EM field is much higher, both in the dielectric and in the liquid, as compared to the case of the same pure liquid. They also did some simulations (see the screenshot attached) where this is visible.

They give some explanations of the effect (microwave scattering, better penetration) but I'm not fully convinced. I have the impression that this is logically conceivable and explicable in terms of basic physics, especially for people who deal with microwaves. Have you ever seen an effect like this? Can you think of any analogy, a situation where this was previously applied? The microwave frequency was ~260 GHz here but I don't think that matters so much. Why does mixing two dielectrics with different dielectric constant will affect the one with lower dielectric constant in a way that it will "contain" more microwave field?

Thanks a lot for any ideas!
sim_900B9CA5-5056-8D7B-05D2261FB5BDFFC5.png
 
Engineering news on Phys.org
It would help to see the original article.
 
Here you go. It's quite a specific application but the idea and results are described in the abstract.
 

Attachments

Interesting phenomenon. I guess it can be very useful but requirement of low temperatures and strong magnetic fields limit application potential considerably.
 
Low temperature and high magnetic field are necessary for this particular kind of experiment (magnetic resonance, hiperpolarization) but I think the phenomenon of "confining" microwaves in a dielectric structure is much more general and applies to wide range of situations.. here indeed the wavelength is ~1mm which is shorter than typically used in communication.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top