Does magnet wire always have to be used in the production of solenoids

Thread starter B166ER
Start date Jun 17, 2005
Tags

Magnet Wire

AI Thread Summary

Magnet wire is essential for producing functional solenoids and transformers, primarily due to its conductive properties. Typically, copper is used as the wire material, which is diamagnetic. For optimal performance in these devices, incorporating a ferromagnetic core, such as iron or ferrite, is common practice. This combination enhances the efficiency and effectiveness of the solenoid or transformer. Using magnet wire is crucial for achieving satisfactory operation in these applications.

Jun 17, 2005

B166ER

Does magnet wirealways have to be used in the production of solenoids or Transmformers?

Engineering news on Phys.org

Jun 17, 2005

willib

yes .. if you want it to work half way decent

Jun 18, 2005

SGT

The wires used to produce solenoid and transformers are usually copper, that is diamagnetic.
For high performance devices it is usual to use a ferromagnetic core (iron, ferrite, ...)

Thread '3-terminal device external modeling'

Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...

View full post »

Thread 'When 50,000 volts go through a wire at 5,000,000 FPS - The Slow Mo Guy'

View full post »

Thread 'Question about the voltage between two charged capacitors'

suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...

View full post »