Electromagnetic Absorption Frequency

AI Thread Summary
Microwaves are known to be absorbed by water molecules due to their molecular structure, but the absorption characteristics of nitrogen molecules are less understood. Resources like the NIST database and various academic papers provide insights into the molecular nitrogen absorption spectrum, though calculations can be complex and may not yield expected results. A specific formula for calculating vibrational wavelengths of nitrogen was discussed, but it produced unexpectedly long wavelengths, suggesting a need for verification. The discussion emphasizes the importance of understanding the limitations of the equations used in these calculations. Overall, further research and careful analysis of existing literature are recommended for accurate insights into nitrogen's absorption properties.
TESL@
Messages
122
Reaction score
8
Hi, I have just registered to ask something that I can't find the answer anywhere.

As you know, microwaves are absorbed by water molecules because of its shape and angles etc. I wonder which wavelength can be absorbed by nitrogen molecules in the air or at least need to learn a method to calculate.

Thank you.
 
Physics news on Phys.org
Search for "Molecular nitrogen absorption spectrum".

You will find lots of details at NIST:
http://webbook.nist.gov/cgi/cbook.cgi?ID=C7727379&Mask=1000

You can forget calculations unless this is your research specialty - but see this paper:
"On the complexity of the absorption spectrum of molecular nitrogen"
http://www.nat.vu.nl/en/sec/atom/Publications/pdf/Vieitez-08-ML.pdf

However, this lecture has a very simple formula on page 8; of course it only gives one frequency, so it is based on a very simple model: http://www.geo.mtu.edu/~scarn/teaching/GE4250/absorption_lecture.pdf

But the lecture is also worthwhile - it provides a great deal of information, but not much on N2.

Also see "The spectrum of molecular nitrogen": (behind paywall)
http://scitation.aip.org/content/aip/journal/jpcrd/6/1/10.1063/1.555546
 
  • Like
Likes 1 person
Thanks UltrafastPED.
 
Absorbtion_Frequency.png


When I calculate, I get a result of wavenumber in terms of s/(m√m) whereas it actually in 1/m. How can it be correct?
 
Last edited:
I don't know where that equation came from, and I don't trust it.

Search for Chapter 6 Ideal Diatomic Gas;
This lecture goes through a typical derivation process ... if you read it carefully you may find out how the above formula was generated, and its limitations.
 
Ok, from the equation v=(1/2∏)*√(k/u), and k=22,6*105dyn/cm for N2, the wavelength of vibration has been found 13517,28566 nm. This is way too long, I expected ultraviolet bands.

By the way, I took the previous equation from http://www.geo.mtu.edu/~scarn/teaching/GE4250/absorption_lecture.pdf pg:8.
 
Last edited:
Is there anyone to verify?
 
Back
Top