Flight Path Angle: Definition & Effect on Airplane

AI Thread Summary
Flight path angle (FPA) is the angle between the aircraft's trajectory and the horizontal plane, affecting performance during climb or descent. It differs from angle of attack (AOA), which is the angle between the wing and the oncoming air, and while lift primarily depends on AOA, FPA also influences lift through potential energy changes. When FPA changes, AOA can vary, but there is no fixed relationship between the two; for instance, an aircraft can gain altitude in strong thermals with low AOA and high speed. The climb rate is determined by engine power relative to maintaining level flight. Understanding these angles is crucial for analyzing aircraft performance in various flight conditions.
amirshah
Messages
7
Reaction score
0
Hello,

What is flight path angle and how does it affect an airplane? What is the difference between flight path angle (glide angle or climb angle) and angle of attack? When the flight path angle is changed during flight, does the angle of attack also changed? I found that lift is always rely on angle of attack only but from aircraft performance discussion I have seen lift also changed with the variation of flight path angle (L = W cos*gamma). Could you explain what does that mean? I reaaly confused with these two angles.
 
Engineering news on Phys.org
Thanks. At least, I have known the relationship between angle of attack and pitch angle. How's about angle of attack and flight path angle. In the equations of motion especially in flight performance, flight path angle directly affect the performance calculation.
 
Flight path angle is a factor in performance because the aircraft is either gaining or losing potential energy (for an angle other than zero). It is similar to cycling up or down a hill. In still air the climb rate is determined by how much engine power is available over and above simply keeping the aircraft in level flight.

There is not a fixed relationship between AOA and flight path. I have been in strong thermals with the nose pushed over at a low angle of attack and a high airspeed, still gaining altitude. The positive flight path angle in a case like that is mostly due to the moving airmass rather than engine power.

Conversely there is a maneuver call slow flight in which the AOA is nearly max at low airspeed in level flight.

Hope this helps.
 
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Back
Top