Good job while in college. Looking for advice

  • Thread starter Thread starter JerryG
  • Start date Start date
  • Tags Tags
    College Job
AI Thread Summary
A junior electrical engineering student seeks advice on finding a flexible job that accommodates a full-time school schedule, as their current position is stressful and not supportive of their studies. They express interest in online job opportunities, leveraging their expertise in power systems. A respondent shares their positive experience working as a junior engineer at Hewlett Packard, highlighting the flexible schedule and valuable learning opportunities. The discussion emphasizes the importance of balancing work and education while managing stress. Finding a suitable job can significantly enhance the college experience and academic performance.
JerryG
Messages
58
Reaction score
0
Hey guys. I'm currently a Junior electrical engineering student. I'm working and going to school right now, but my current job is not very accommodating to a full time school schedule. I would like to work somewhere that has a pretty flexible schedule so I can take more classes. Plus, my current job is extremely stressful and is really making it hard for me to concentrate on school. Can any of you guys suggest a good place to work while in college? Where did you work while getting through school.
 
Engineering news on Phys.org
I am looking for internet job too, I am expert in power system.

BEST REGARDS
M.S.Jafarpour
 
I'm Doing the network marketing thing ... it's helpful ...
 
I had a nice part-time job as a "junior engineer" at Hewlett Packard while attending college (1954-58). Work schedule was very flexible, and HP was only ~2 miles from campus. Learned a lot about high frequency vacuum tube circuit design. Like in vacuum-tube oscilloscopes. Shortly after graduation, no one was using vacuum tubes any more.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...

Similar threads

Back
Top