How Does Weight Change When an Object Falls?

AI Thread Summary
When an object falls, its weight remains constant, but the force it exerts upon impact can vary based on the height from which it falls and the material it strikes. The velocity upon impact can be calculated using the formula V = Sqrt(2as), where 'a' is the acceleration due to gravity and 's' is the height fallen. The impact force depends on the stopping distance; a harder surface results in a shorter stopping distance and a greater force upon impact. Weight is indeed a measure of force, specifically the gravitational force acting on an object. Mixing imperial and metric units can complicate calculations, but it is manageable if consistent conversions are applied.
Theatre_Kid
Messages
2
Reaction score
0
Mostly for self interest:
If I drop a 1lb weight from 15 ft (5m), what does it weigh when it hits the floor.
If I have a 10lb weight and it drops from the same 5m shelf, does it weigh 10 times as much as my 1 lb weight from the 1st question?

I may have the wrong terminology, but basically the 1lb weight in my hand weighs 1lb. If I through it in the air and catch it, it is heavier when it hits my hand, because of the force of gravity pulling it back down. If that fall is 5 meters, what is the weight the floor will feel when the object hits the ground.
 
Physics news on Phys.org
Hi Theatre_Kid. http://img96.imageshack.us/img96/5725/red5e5etimes5e5e45e5e25.gif

Without knowing the muscle strength you can adeptly repeatedly exert, I don't think it is possible to make a comparison the way you are asking.

A comparison that could be made is: if a 1lb weight when gently sat on a spring depressed it by x inches, how many inches would the spring depress if that weight were dropped on it from 15 ft.
 
Last edited by a moderator:
I may have the wrong terminology, but basically the 1lb weight in my hand weighs 1lb. If I through it in the air and catch it, it is heavier when it hits my hand, because of the force of gravity pulling it back down. If that fall is 5 meters, what is the weight the floor will feel when the object hits the ground.

When the 1lb weight hits the floor it will be traveling at some velocity V. You can work that out using...

V = Sqrt(2as)

where
a is the acceleration due to gravity (9.81m/s2)
s is the displacement or height it fell from (eg 5m)

The problem is working out the force with which the weight hits the ground. Suppose the ground was soft and the weight sank in (s) 5cm (0.05m) before coming to rest. You could run the equation in reverse to work out the average deceleration (d)...

d = V2/2s

Then you could use Newtons laws to estimate the force (F) ...

F = md

where
m=mass of the object.

Note that the harder the ground the shorter the stopping distance. If the 1lb weigh somehow hit the ground and stopped dead the deceleration would be very large, potentially infinite. Therefore the force on the object/ground would also be very large. That's why things dropped onto concrete tend to break.

(Aside: The above makes some assumptions that aren't always valid but that's another story).
 
Thank you, both for the welcome and the answer.
Is there a way to know the stopping distance? I get that concrete would be shorter than wood or foam, but is there a property (density? hardness) of a given material that would let me know how to calculate that, or something I just make an assumption for and move on?

Also, am I right in believing that weight (pounds) is a measure of force? IE it measures the force of gravity on a given object?

Finally, does it matter if I'm mixing imperial and metric units (a 1lb weight falling 5 meters)
 
Hi there, im studying nanoscience at the university in Basel. Today I looked at the topic of intertial and non-inertial reference frames and the existence of fictitious forces. I understand that you call forces real in physics if they appear in interplay. Meaning that a force is real when there is the "actio" partner to the "reactio" partner. If this condition is not satisfied the force is not real. I also understand that if you specifically look at non-inertial reference frames you can...
I have recently been really interested in the derivation of Hamiltons Principle. On my research I found that with the term ##m \cdot \frac{d}{dt} (\frac{dr}{dt} \cdot \delta r) = 0## (1) one may derivate ##\delta \int (T - V) dt = 0## (2). The derivation itself I understood quiet good, but what I don't understand is where the equation (1) came from, because in my research it was just given and not derived from anywhere. Does anybody know where (1) comes from or why from it the...
Back
Top