Does cutting magnetic flux lines create a rate of change of flux linkage?

[Ivore]

Hi, this may be really easy but..
I understand that to have an induced e.m.f , we can either have a rate of change of magnetic flux linkage ( ac source ) or cutting of flux ( like a plate oscillating and cutting through a magnetic field produced by a solenoid ). However does cutting of flux creates a rate of change of magnetic flux linkage ? Is rate of cutting of flux the same as saying rate of change of magnetic flux ? Or are they both different ?

 

[Hesch]

However does cutting of flux creates a rate of change of magnetic flux linkage ?

Whenever you insert a conductive, moving plate in a magnetic field ( induced by an electromagnet ) the magnetic field will be weakened and will change it's path, also through the electromagnet. Thus the flux will be changed through ( some of ) the windings due to Eddy currents in the the plate, that will induce a counter mmf.

Flux linkage is the connection between the flux path and flux strength through the windings.

Even if you insert a non moving iron plate, the magnetic field will be changed steady state due to change of permeability in the surroundings of the magnet.