What is the Significance of Icw, Icm, Icu, and Ics in ABB Tmax Circuit Breakers?

  • Thread starter Thread starter odedix
  • Start date Start date
AI Thread Summary
Icw, Icm, Icu, and Ics are critical specifications related to the performance and protection capabilities of ABB Tmax circuit breakers. Icw refers to the rated current for continuous operation, while Icm indicates the short-circuit current rating. Icu is the ultimate short-circuit breaking capacity, and Ics represents the service short-circuit breaking capacity. Understanding these terms is essential for selecting the appropriate circuit breaker for specific applications, as terminology may vary by region. For detailed definitions and specifications, consulting the ABB catalog or relevant datasheets is recommended.
odedix
Messages
3
Reaction score
0
Can you explain to me what the meaning of Icw, Icm 'Icu, Ics,
 
Engineering news on Phys.org
We might assume these are currents, beyond that we will have no idea without more info...are you reading these on a datasheet, homework, schematic ?
 
It appears in the catalogs of electronic protection of the brekers ABB
 
Is it on line... can we have a link? ( Different countries and regions have different terminology - especially when referring to electrical protection)
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

What secondary circuit breaker should I use for my fridge compressor?
Replies
8
Views
1K
Difference between a circuit breaker and a load break switch?
Replies
11
Views
9K
What is meant by electronegative gas?
Replies
1
Views
11K
Understand the Current Consumption of an IC in its Datasheet
Replies
5
Views
5K
Tripping Behavior of Circuit Breakers
Replies
42
Views
4K
IC Physical Design Software Inquiry
Replies
11
Views
2K
What Gauge Wire Should Be Used for the Neutral in a 240VAC Circuit?
Replies
13
Views
2K
Electronic circuit breaker design
Replies
23
Views
4K
Designing an Electronic Timer Circuit Using NE555 IC or BC548 Transistor
Replies
4
Views
2K
Is the circuit breaker amperage the rms amperage
Replies
5
Views
6K

Hot Threads

Recent Insights

Back
Top