Need Help with Coolant Flow Calculation for Engine Heat Rejection?

atulmalode
Messages
9
Reaction score
0
could any guide me in Coolant Flow Calculation for finding heat rejection of engine through various system.
 
Engineering news on Phys.org
I'm sorry you are not generating any responses at the moment. Is there any additional information you can share with us? Any new findings?
 

Thread 'Bubble formation in 4 mm gap vessel'

How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
View full post »
Thread 'Calculate minimum RPM to self-balance a CMG on two legs'

Thread 'Calculate minimum RPM to self-balance a CMG on two legs'

Here is a photo of a rough drawing of my apparatus that I have built many times and works. I would like to have a formula to give me the RPM necessary for the gyroscope to balance itself on the two legs (screws). I asked Claude to give me a formula and it gave me the following: Let me calculate the required RPM foreffective stabilization. I'll use the principles of gyroscopicprecession and the moment of inertia. First, let's calculate the keyparameters: 1. Moment of inertia of...
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Similar threads

Why Did the Temperature Rise in a Sealed Automotive Cooling System?
Replies
18
Views
2K
Cooling a marine engine while testing
Replies
6
Views
2K
Behavior of heat addition in a compressible flow
Replies
9
Views
3K
How Can I Determine the Maximum Flow Rate for a Heat Exchanger Cooling Oil?
Replies
1
Views
2K
Venturi injector suction not adequate
Replies
19
Views
5K
Heat cross exchanger
Replies
3
Views
3K
How to design a radiator to dissipate heat generated by a 39 KW rotary engine?
Replies
6
Views
5K
Coolant Mass Flow Rate Through Subchannel in Nuclear Fuel Assembly
Replies
1
Views
2K
How can I avoid Foaming in my cutting fluid tank? (attached drawing for reference)
Replies
18
Views
3K
I Effects on Engine Overheating and Pressure Dynamics
Replies
4
Views
2K

Hot Threads

Recent Insights

Back
Top